Machine Shop
Steam engine parts
Wed, Aug 27th 2003 (10:36 PM)
800x600 1600x1200
Machine Shop
aligning a bolt (from my rotary table) to turn it down to fit the T-slots on the TAIG mill
Wed, Sep 3rd 2003 (6:53 PM)
600x800 1200x1600
Machine Shop
Parts for my first steam engine, the Bijou from the book, "Steam and Stirling Engines You Can Build"
Sun, Sep 14th 2003 (3:26 PM)
800x600 1600x1200
Machine Shop
Milling the standard for my first steam engine
Sun, Sep 14th 2003 (3:30 PM)
800x600 1600x1200
Turning a collet
Turning a 15deg taper on a collet for the TAIG mill
Sat, Oct 4th 2003 (9:08 PM)
800x600 1600x1200
Turning the collet taper
Sat, Oct 4th 2003 (9:08 PM)
800x600 1600x1200
New 1/8" collet
New collet on right, model on left
Sat, Oct 4th 2003 (10:33 PM)
800x600 1600x1200 Cropped (542x372)
New 1/8
New 1/8" collet in use holding 1/8" shank 3/32" endmill
Sat, Oct 4th 2003 (10:37 PM)
800x600 1600x1200
Radial-Five parts
Crankshaft parts for Kouhoupt's "Radial Five" (from plans in "Home Shop Machinist")
Tue, Oct 28th 2003 (9:15 PM)
800x600 1600x1200
Also in: Engine: Radial-Five
Turning a large brass wheel for a steam engine
Tue, Oct 28th 2003 (10:47 PM)
800x600 1600x1200
Also in: Engine: Unusual Steam Engine
Radial-Five parts
Drilling bolt holes in the front propeller plate on the rotary table. T-nut stock milled from square stock can be seen on the right.
Fri, Oct 31st 2003 (9:14 AM)
800x600 1600x1200
Also in: Engine: Radial-Five
Drilling on the rotary table
Drilling the front propeller disk for the Radial Five on the rotary table
Fri, Oct 31st 2003 (9:25 AM)
800x600 1600x1200
Also in: Engine: Radial-Five